Canadian Mustang Owners Club - Ford Mustang Forums

Canadian Mustang Owners Club - Ford Mustang Forums (https://www.cmoc.ca/)
-   4.6L 4v (https://www.cmoc.ca/4-6l-4v-3/)
-   -   thunking & cracking (https://www.cmoc.ca/4-6l-4v-3/thunking-cracking-1752/)

SNAKEBITE Apr 28, 2005 09:10 PM

The chap beside your name I mean :cheers:

Rondosa Apr 28, 2005 09:44 PM


Originally Posted by paul
The chap beside your name I mean :cheers:


oh haha. it's an abercrombie and fitch model. it's my answer to the :Argue: bouncy boob avatars that drive me crazy. :tup



edit: WO! FYI http://forums.bradbarnett.net/index.php?showtopic=22696

SNAKEBITE Apr 29, 2005 10:52 AM

I guess all is fair in love and war :cheers:

Thump_rrr Apr 30, 2005 04:41 PM

TSB 05-9-11

FRONT SUSPENSION POPPING NOISE WHILE TURNING RIGHT OR LEFT - VEHICLES BUILT BEFORE 4/8/2005

Publication Date: April 27, 2005

FORD: 2005 Mustang


ISSUE:
Some 2005 Mustang vehicles built before 4/8/2005 may exhibit an intermittent popping noise from the front of the vehicle while turning left or right. The noise will typically occur during low speed maneuvers and may occur multiple times while turning.

ACTION:
On both sides of the vehicle, install a revised upper strut bearing assembly. If the vehicle was built before February, 2005 it may also be necessary to install a lower spring seat isolator if one is not already present. Refer to the following Service Procedure.

SERVICE PROCEDURE

Remove the strut and spring assembly. Refer to Workshop Manual Section 204-01.
Disassemble the strut and spring assembly.
If the springs do not have a rubber isolator on the bottom spring coil, install isolators. Clean off any dirt prior to installing the isolator. The isolator should be installed 4" (100 mm) from the end of the coil (Figure 1).


Figure 1 - Article 05-9-11


Reassemble the strut and spring. During reassembly, make sure the lower spring coil is butted up against the lower spring seat on the strut and the upper spring coil is butted up against the upper bearing assembly.
NOTE: INSTALL ALL NEW FASTENERS DURING REASSEMBLY.



NOTE: VEHICLE ALIGNMENT IS NOT REQUIRED AFTER THIS REPAIR.




PART NUMBER PART NAME
5R3Z-18183-A Strut Mount (Bearing)
5R3Z-5l302-A Spring Isolator
W520215S440 Strut Upper Nut
N807144S440 Stabilizer Bar Nut
W520112S440 Strut To Body Nuts
W711091S900 Strut Bolt Nuts
W709870S439 Strut Bolts


WARRANTY STATUS:
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage

OPERATION DESCRIPTION TIME
050911A 2005 Mustang Install A Revised Upper Strut Bearing Assembly And A Lower Spring Seat Isolator On Both Front Struts (Do Not Use With 18124A, 18124AT, 5310A, 5310AT, 3455A, 3455AT) 1.5 Hrs.

DEALER CODING
BASIC PART NO. CONDITION CODE
18183 42

5PointOHNO Apr 30, 2005 06:50 PM

^your Avatar perhaps

SNAKEBITE Apr 30, 2005 07:32 PM

Thanks for the info. What are the chances the dealership would know about this. In the past they were replacing the part with the same defective pieces. :cheers:


All times are GMT -5. The time now is 05:22 AM.


© 2026 MH Sub I, LLC dba Internet Brands