1990 5.0 wants to stalling
 

Hi Guys,

I am new to the forum and have a modified 1990 5.0 that is fairly modified. SC intake, heads, and exhaust. I have a tuned Kenne Bell chip and everything was running perfectly until I had taken track lessons and ended up with a burnt speedo cable (which) I have yet to replace. The cable runs approx 6" from my header and it still melted.
The motor starts and idles nice but when I press down on the clutch (anytime, not even in gear) to disengage from the flywheel the motor wants to stall. I have to rev it to keep from stalling it and as soon as it is in gear and I am moving not a problem. Then there after every time I change gears same issue. Weird since I figure less load when the clutch is off flywheel? What can be the problem?:?

Your help is needed.

Check your engine grounds, TPS AIC it could be coincidence that issues started when cable melted. Good Luck