Canadian Mustang Owners Club - Ford Mustang Forums

Canadian Mustang Owners Club - Ford Mustang Forums (https://www.cmoc.ca/)
-   5.0L (https://www.cmoc.ca/5-0l-36/)
-   -   Biggest Cam & Still pass e-test? (https://www.cmoc.ca/5-0l-36/biggest-cam-still-pass-e-test-15111/)

MENMEL 01-16-2011 01:59 PM

Biggest Cam & Still pass e-test?
 
Would anyone know what is the biggest cam I could run, and still pass an e-test in Ontario? Besides an FMS E303. Thanks.

SNAKEBITE 01-16-2011 04:37 PM

Welcome aboard and one of the experts will be along momentarily. Good luck with your project!

VAEM 01-17-2011 06:17 PM

1LOW03GT ...... over to you.

pprince 01-18-2011 11:08 AM

E303 or B303. If you look at the Ford racing catalogue I believe those are the only two emission certified cams.

SNAKEBITE 01-18-2011 03:49 PM

small choice for sure. Move out here no e-tests lol

VAEM 01-18-2011 07:17 PM

^^^^ Gods country!

foxy89 04-01-2011 09:51 PM

Mine has a b303, passed fine at 40 roll, at idle wasn't even close, way too much fuel. car has heads/cam(obv)/intake, no pollution pump and mac shorties. Possible to pass at idle with tuning? Sorry to high-jack thread but this may help you too.

1WLD BRD 04-02-2011 01:57 PM


Originally Posted by foxy89 (Post 147448)
Mine has a b303, passed fine at 40 roll, at idle wasn't even close, way too much fuel. car has heads/cam(obv)/intake, no pollution pump and mac shorties. Possible to pass at idle with tuning? Sorry to high-jack thread but this may help you too.

retry your test, but pull the spout connector just before it goes in, and add 3 liters of methyl hydrate. garauntee you will pass the next test that way.:shakeit:

foxy89 04-04-2011 12:01 PM

Spout connector? Sorry Im abit of a newbie. Yes have heard about methyl hydrate though. Thanks for your time. Hope this is helping original poster too.

1WLD BRD 04-04-2011 02:21 PM

1 Attachment(s)

Originally Posted by foxy89 (Post 147560)
Spout connector? Sorry Im abit of a newbie. Yes have heard about methyl hydrate though. Thanks for your time. Hope this is helping original poster too.

yes it is that little dead end plug that is attached to your distributor:

Attachment 15020

See the plug in the blue square? unplug that little gray thing in the end of it. what that does is prevent the computer from advancing the timing, which will lower you emmisions by a ton.


All times are GMT -5. The time now is 04:36 AM.


© 2024 MH Sub I, LLC dba Internet Brands