Cylinder heads
 

What is the bolt sequence I should use when tighting stock heads down.

This is from ford manual. for a 95 5.0...should all be the same.thumb:

NOTE:
The RH cylinder head has one stud at location 8. The LH cylinder head does not.
The cylinder head bolts are tightened in three steps:
Refer to the following illustration for the tightening sequence.

a.Tighten all bolts in sequence to 34-47 N-m (25-35 lb-ft).

b.Tighten all bolts in sequence to 61-75 N-m (45-55 lb-ft).

c.Tighten all bolts in sequence an additional 1/4 turn (85-95 degrees).
http://i105.photobucket.com/albums/m...erheadcopy.jpg

Thanks alot, but I have a bigger problem. How do I identifty which is the righ hand and left hand heads, and which way do the gaskets go on?

the holes for the smog control exhaust go on the back, the holes for brackets go on the front :P

the holes on the front and back are the same, this is throwing me way off.

It does not matter ford heads are same left and right fit right and left one casting for both thats why plugs are the way they are