Canadian Mustang Owners Club - Ford Mustang Forums

Canadian Mustang Owners Club - Ford Mustang Forums (https://www.cmoc.ca/)
-   General Mustang Tech & Chat (https://www.cmoc.ca/general-mustang-tech-chat-46/)
-   -   2003 mustang Gt stalled in neutral while heat was blasted (https://www.cmoc.ca/general-mustang-tech-chat-46/2003-mustang-gt-stalled-neutral-while-heat-blasted-21802/)

Ironhide 11-02-2018 01:10 PM

2003 mustang Gt stalled in neutral while heat was blasted
 
Trying to figure what the issue is with the car. It’s sending out an error code p0113. Maf, iac? The car stalled in neutral and the rpms fluctuate when the car is started. It jumps from 1000-2500.. back down back up. What could be the issue? Car was warmed up too.

Mudlite 11-02-2018 02:46 PM

Fluctuating RPM's with heater on
 
What you described sounds to me like an AIV acting up. My Sn95 was doing that. I removed the AIV and cleaned it with brake cleaner and misted some oil onto the piston so it wouldn't stick, then went through the process of setting base idle and yes accessories running will affect idle. Here is the procedure.
Disconnect neg terminal (batt
Disconnect AIV
Reconnect neg terminal
Start engine
Set RPM with stop screw
Turn off engine
Reconnect AIV
Start engine all accessories off
Run for two minutes
Shut off for two minutes
Run for two minutes all accessories on
EECiv(computer} should have "learned" the new idle spec
Its a fairly easy adjustment and set up. My car now idles a little over 600 and the fluctuation in RPMS has stopped

Ironhide 11-03-2018 10:25 AM

Thanks man, I’ll definetly look into this!


All times are GMT -5. The time now is 05:53 AM.


© 2024 MH Sub I, LLC dba Internet Brands