Canadian Mustang Owners Club - Ford Mustang Forums

Canadian Mustang Owners Club - Ford Mustang Forums (https://www.cmoc.ca/)
-   General Mustang Tech & Chat (https://www.cmoc.ca/general-mustang-tech-chat-46/)
-   -   anyone with shorty headers? (https://www.cmoc.ca/general-mustang-tech-chat-46/anyone-shorty-headers-7733/)

gt98 01-27-2007 06:39 PM

anyone with shorty headers?
 
just wondering if anyone has shorties on there cars.. i know tons of ppl say there not worth it but i cant affoard the extra cash for the longtubes....

i want to hear some feedback as in to sound?power?

Bubba_Lane 01-27-2007 06:49 PM

i had ford racing shorties on my cobra, they did make a sound difference, but nothing for power, install was a bitch too cause of the monster heads. but i think long tubes and what you got now would sound sick.

Terminal Velocity 01-27-2007 07:06 PM

if your going to put cams in your car then definatly if not.............its up to you but i dont think youll see tremendous gansthumb:

tear u a new 1 01-28-2007 03:19 AM

ive done my home work as for shorties not much gain , long tubes some but not much. it all depends on your budget and what you want outa your car thumb:

Stang Illusions 5.0L 01-28-2007 03:53 AM

If your going to keep upgraded your car I would go long tubes. Nothing like doing the same job twice.

Ponyryd 01-28-2007 08:31 AM

Go shorties, mush easier to install, easier access to starter, trans, etc.... The difference between the two is minimal for a street car, you would never notice. The long tubes are said to give a bit more top end power but you'll lose some low end power, so the mid-range is pretty much the same. Many believe the difference in power is big because when compainies are dyno testing a product, they go with peak-power for the ads so you'll think it's a huge difference when it's not. If you spend most of your time at 5500+rpm then go long tubes, street cars usually run quite a bit lower.

Terminal Velocity 01-28-2007 10:05 AM


Originally Posted by tear u a new 1 (Post 72748)
ive done my home work as for shorties not much gain , long tubes some but not much. it all depends on your budget and what you want outa your car thumb:

Please donate to AA and stop drunkin posts like these .....thank youreport:

j-roc 01-28-2007 04:31 PM

When my engine was out I threw on a set of BBK shorties, they are close to equal length so they might be worth a tiny bit more power than other shortes. Not bad for $300 too, the flanges & welds are good and they fit nicely. Didn't want to have to get a new X pipe so I did not get longtubes.

cruisin 01-28-2007 10:42 PM

You might as well get it done right the first time. Seems like shorties are a budget way to do things. Its like throwing on an axle back for sound rather than working further towards a restricted area like a CAT back or even headers back. If ya want sound go for it but if ya plan on continuing your build do the job right once. you'll be back for more later

Ponyryd 01-29-2007 07:24 AM

^The term "axle back" only applies to the '05+ mustangs since there mufflers are at the rear of the car, a "cat back" is the same thing as an axle back as it replaces the mufflers and piping before (to the next joint) and after them.thumb:


All times are GMT -5. The time now is 03:17 AM.


© 2024 MH Sub I, LLC dba Internet Brands