Can someone snap a picture of how the rear ABS speed sensor wires are run? I just installed my new axle and can find where the push in pin connects on the housing.

Thanks!

 

If I crawl under my car thats outside in the driveway (-20C, snow), what exactly would I be looking to take a pic of, I can today after work, sometime after 12pm today, just let me know what I'm looking for.

 

If you look at the back of the bracket your caliper is bolted to you will see a wire that comes up and hooks up near the area the brake line attaches to the car. I just need to see how that wire is routed. Also about the middle of the wire there there is a push in type clip that my new axle does not have a hole for so I just need to see where it clips into.

Thanks!

 

Hope these help a little let me know and I'll try again if they dont.

[IMG][/IMG]

[IMG][/IMG]

[IMG][/IMG]

[IMG][/IMG]

 

The 3rd one probably would of if not for the snow covering it. If you get a chance with no snow on it that would be good but don't go out of your way. I am in no rush since the car is stored.

 

Mighty nice of you

 

Hey, I'm just sitting here on the couch anyway,

Is this the wire.....

[IMG][/IMG]

[IMG][/IMG]

[IMG][/IMG]

Running out of sun now but it will be warm tommorrow here (all the way up to 0, LOL), so I can try again hopefully some snow will melt off then.

 

I think the clip is just under the second bolt there.

 

Perfect! Thanks!

I was not even looking in the right place. Now I know.

 

Ur a good man there def67 !!