What mods have you completed thus far and/or will your plans be done by mid April

 

Long list but this weekend complete new drivetrain from the crank back then the procharger.

 

got a huge list, haven't even started.

i suck.

 

I don't even have enough patience to make a list let alone wait. I have parts here waiting on bolts and it's driving me nuts that I can't install them.

 

Nothing done yet, but I've only had it a week, so I plan to do the Borla exhaust at the end of April, and then possibly Ford Racing intake & BBK throtle body, but those two will have to wait until July....gotta love quarterly bonuses.

 

Done...
-JLT installed
-Swarr Bar diff brace installed
-Painted the rear diff
-Got the proper wiring harness hooked to my deck that hooks up to the factory Mach 460 system
-Repainted my calipers,and rotors
-Waxed,and polished the rims inside,and out
-Dusted the mustang every couple of weeks

Still need to do...
-Get my axle tubes welded
-Purchace a SCT X3 so can get take out the SCT chip,and have more usability
-new sticky tires to drag again,if funds allow since i've done quite a bit already.
Funny thing is i only planned on getting the SCT X3,and the JLT LOL!

 

Chrome Roushcharger installed.
Boost Gauge
Lowered the front same as the rear with Roush lowering Springs
Strut Caps
5 coats of wax due to winter Hibernation
Still need front tires and wouldn't mind installing a short shifter
Cheers to a early spring!

 

Purchased but not installed:
- KR Axle Backs
- Steeda Upper Control Arm
- Clarion in dash DVD

Finished:
- Ford Racing push button start

Going to purchase:
- new shelby trunk letters and termplate to centre them accross the trunk
- shift ****, just don't know what yet

Thinking about
- Wheels
- pulley/tune/cai
- lowering springs

 

I am putting on a set of rear slotted/drilled disc brakes.

I have a set of tinman frame connectors to put on too.

 

Planned to install all my parts sitting in my basement.

Ported and polished Cobra intakes
GT40 heads
E 303 cam
pick up the Differential from Mike and install

Still want:
70mm T body
bigger mass air sensor
maybe get a set of Long tube headers.