Hi,
does anyone know if there is a larger throttle body for the 2.3 turbo or n/a engine, or if someone has made one up (if so what did you use)?

Thanks
Matt

 

no there is not a after market TB.

BUT there is a way!

u can ether get a 1994-1995 mustang 5.0L TB/ or a thunderbird super coupe TB they are both 60mm.

there is some modifations you have to do tho.
you are going to have to port your upper intake to match the TB also your going to have to move your throttle cable back a bit.. { make a home make braket or http://www.40bob.com/images/brackets910002.jpg}

40bob have some very good quality parts for the 2.3L turbos...

hop i have helped

 

I was looking at going with a 75 mm TB if i was going to go it. do they make anything that will work, with alittle modification from a 94-95 stang, or supercoupe

 

iv never herd of any 2.3L guys using a TB any bigger then 65mm trust me that plunty big..

from a stock TB

 

want to go that big so once the turbo and everything goes in, it will breath good and hopefully better throttle responce, and looking at running at least 30lbs of boost

 

well idk what to tell you

have never gone n/e bigger then 65mm or even herd of any one doing it.

 

to go 65 wat would be need to do that, and with an n/a block will that make the engine run wrong

 

well you have to port your upper intake to match the 65mm TB also need to ether make a braket or buy one from 40bob.
thats it o and also wire up your TBS to fit the one that cxomes on the 65mm TB

and the motor should run fine.

 

30 pounds sounds crazy can they really take that ?

 

^^ I hope so, but before the numbers get that high the entire block would be redone, and hopefully the block and everything else could take it