i need your advice guys !

i want to sell my head and intake , but i realy have no idea how it worth .

my head are E7TE fully ported , head are brand new rebuilt , milling .010 , 5 angle valve job , i have a set of stock rocker w/20000km . lower intake is full ported too , runner #5 is very smooth , upper intake is ported to 70 mm and i sold intake w/65mm throttle body+spacer . intake is polish like crome . very nice look

thanks !! :biggrin:

 

You could get anywhere from $300-$600 for the heads, depending on the work done and if they've been run at all. You could get $100-$150 for the lower intake, maybe $200 if you really push it and find the right buyer.
SS

 

nice .. it s more than i tough .

my intake is Tmoss ported so i know it flow really good .

so if i sold my head and u/l intake for 350$ and the guys give my 2 head freshly rebuilt and .010 milling too , whit is u/l intake ... souds a good deal ?? it cost 110 for clean , milling , new seal and valve job for both head .

what you think ??

 

if the heads have had a good porting and NO milling by someone like thumper i'd be interested in the set, if not i'd take the lower intake....

 

thanks for your interest but they are already sold , and i just buy a 96 explorer engine near brandford , ontario .

everything in my head and intake is made by a professional .. ME . and i will have another set of head and intake to port and make them more powerfull , i will sell the kit as i finish the porting job . everythings will be like new :biggrin:

 

Your trailer at the bottom is too funny. Domestic vs Honda