What valve springs to use???
 

I recently acquired a set of Edelbrock Performer heads #60379 (no springs/valves included 1.90 in /1.60 ex) for my '92 5.0. This is my first go at a 5.0

I'm going with:
GT 40 upper/lower 1"spacer
Speed density CAI 3" with a '95 slot MAS
SCT Eliminator chip and custom tune (to come)
Professional Products fuel rail kit and reg
BBK 65mm TB and EGR spacer
24# injectors
TFS Stage 1 cam
Crane Energizer 1.7 RR
Comp cams 6.25" x 5/16" push rods

The Edelbrock website is confusing. Tech keeps you on hold forever!

What spring kit is recommended? (I want a complete kit.)
What timing chain should I use?

... and what degree timing with all of the above (I have 11* now)

There's a lot of good stuff out there, and a lot of junk as well.

I've heard that beehives are good, doubles are better, some have crappy seats, locks or retainers, etc.

Thanks!

(Sorry, I originally posted in wrong forum. Oops!)

Go with a Comp Cams spring kit with locks and retainers.
Call there tech line and tell them your cam specs and they will tell you what springs are required. This way there is now guess work.

Tech Support: 1-800-999-0853
General: 901-795-2400
Fax: 901-366-1807

I have the same cam and I went with a comp cams spring but I can't find the part number... I'll keep looking if I find I will post

i bought another engine for my car . . . 302 done .20 over with forged flat tops and it has either a B or an F cam (hopefully). . . the guy cant remember the cam used . . . im going to use my stock heads on it. . . should i upgrade the valve springs and which ones should i use. . .
thanks guys

I'm running Performer heads, 1.7 CC ER's, 6.350 x .080 CC Rods, and double valve springs but I cant remember witch ones HAHA