What valve springs to use???
#1
What valve springs to use???
I recently acquired a set of Edelbrock Performer heads #60379 (no springs/valves included 1.90 in /1.60 ex) for my '92 5.0. This is my first go at a 5.0
I'm going with:
GT 40 upper/lower 1"spacer
Speed density CAI 3" with a '95 slot MAS
SCT Eliminator chip and custom tune (to come)
Professional Products fuel rail kit and reg
BBK 65mm TB and EGR spacer
24# injectors
TFS Stage 1 cam
Crane Energizer 1.7 RR
Comp cams 6.25" x 5/16" push rods
The Edelbrock website is confusing. Tech keeps you on hold forever!
What spring kit is recommended? (I want a complete kit.)
What timing chain should I use?
... and what degree timing with all of the above (I have 11* now)
There's a lot of good stuff out there, and a lot of junk as well.
I've heard that beehives are good, doubles are better, some have crappy seats, locks or retainers, etc.
Thanks!
(Sorry, I originally posted in wrong forum. Oops!)
I'm going with:
GT 40 upper/lower 1"spacer
Speed density CAI 3" with a '95 slot MAS
SCT Eliminator chip and custom tune (to come)
Professional Products fuel rail kit and reg
BBK 65mm TB and EGR spacer
24# injectors
TFS Stage 1 cam
Crane Energizer 1.7 RR
Comp cams 6.25" x 5/16" push rods
The Edelbrock website is confusing. Tech keeps you on hold forever!
What spring kit is recommended? (I want a complete kit.)
What timing chain should I use?
... and what degree timing with all of the above (I have 11* now)
There's a lot of good stuff out there, and a lot of junk as well.
I've heard that beehives are good, doubles are better, some have crappy seats, locks or retainers, etc.
Thanks!
(Sorry, I originally posted in wrong forum. Oops!)
Last edited by machthis; 04-13-2009 at 10:25 PM.
#2
Go with a Comp Cams spring kit with locks and retainers.
Call there tech line and tell them your cam specs and they will tell you what springs are required. This way there is now guess work.
Tech Support: 1-800-999-0853
General: 901-795-2400
Fax: 901-366-1807
Call there tech line and tell them your cam specs and they will tell you what springs are required. This way there is now guess work.
Tech Support: 1-800-999-0853
General: 901-795-2400
Fax: 901-366-1807
#4
i bought another engine for my car . . . 302 done .20 over with forged flat tops and it has either a B or an F cam (hopefully). . . the guy cant remember the cam used . . . im going to use my stock heads on it. . . should i upgrade the valve springs and which ones should i use. . .
thanks guys
thanks guys
Thread
Thread Starter
Forum
Replies
Last Post