Lowered Sn95 Thread
#2
I dont have any pictures of mine, but I just lowered it about 1 1/2". I installed Steeda Sport springs that I bought from Pat @ Steeda.. Rides nice, I just replaced my struts with stock replacements (sensatracs). Rear needs to be a little stiffer though, am considering replacing them again with Illumina's.
My car doesnt rub .. I wouldnt go more than 1 inch more. It would definately rub then, It also depends on how low your exhaust hangs.
Oh BTW on a drive up hoist without blocks of wood under the ramps my car is about 1mm away from riping off the front lip on the way down.. So if you lower any lower than what I have be prepared to have a hard time getting a alignment done without doing alot of preparing for your car to go up the ramps.
My car doesnt rub .. I wouldnt go more than 1 inch more. It would definately rub then, It also depends on how low your exhaust hangs.
Oh BTW on a drive up hoist without blocks of wood under the ramps my car is about 1mm away from riping off the front lip on the way down.. So if you lower any lower than what I have be prepared to have a hard time getting a alignment done without doing alot of preparing for your car to go up the ramps.
#3
#5
Eibach Sportlines springs(2.0 in front,1.8 in rear,mine might've drop slightly more though..LOL),Maximum Motorsports Caster Camber plates,and spring iscolators,Energy Suspension rack and pinion off set bushings,and "FOX BODY" (due to the drop) Lakewood 90/10 struts up front,and stock shocks in the rear.
Last edited by 1low03gt; 03-05-2007 at 06:04 PM.
#9
#10
Eibach Sportlines springs(2.0 in front,1.8 in rear,mine might've drop slightly more though..LOL),Maximum Motorsports Caster Camber plates,and spring iscolators,Energy Suspension rack and pinion off set bushings,and "FOX BODY" (due to the drop) Lakewood 90/10 struts up front,and stock shocks in the rear.
I have a 94 GT with a 315/35zr17, will it rub???