Newest tool - Fender Roller
#3
ewwwwww good luck rick, my brother rented one when we did his car i stopped that short in about 10 seconds and did it the old school way with a hammer and dolly , the rollers put to much pressure on the 1/4 panel i was not a fan lol
#5
CMOC Addict
iTrader: (4)
Join Date: May 2006
Location: Winger, but good luck finding that
Posts: 683
they work good, but only if the car doesn't have any rust (the spot welds can break easy), and then it doesn't work at all.
And, its a LONG, SLOW, process.
Well.....you can hurry it, but then your better off beating the crap out of it with a hammer! LOL
Get the area nice and warm, almost to warm to touch, and start on the edge, and work at it slow, and it'll go.
And, its a LONG, SLOW, process.
Well.....you can hurry it, but then your better off beating the crap out of it with a hammer! LOL
Get the area nice and warm, almost to warm to touch, and start on the edge, and work at it slow, and it'll go.
#8
If it doesnt crack I will find something else to cry over.
hows that?
Thread
Thread Starter
Forum
Replies
Last Post