new guy from oshawa, on
#17
my baby isnt on the street right now, in fact shes been off the road most of the summer, im thinking about selling her and moving onto another project, something that isnt a v8, maybe just a 4 cylinder on air ride or something different. but yea she parked in my drive way, im having drive shaft problems
the problem is finding the proper ujoint for it, im using the stock 4 cylinder driveshaft and the new c6 trans i got for it when i did the motor swapcame with a tailstock, i put a ujoint in that tailstock that came with the c6 and mated it up to the 4cyl driveshaft, and about 30 or 40 kms down the road it had terriable vibration problem so i drove it back home hoping nothing was damaged, as soon as i got in my driveway the ujoint, gave out and fell apart, the needle bearings from one of the caps were sitting at the entrance of my driveway , thats how lucky i got, anyone every run into this problem before? not being able to get a ujoint to mate properly to a c6 tailstock, to a stock 4 cyl driveshaft?
the problem is finding the proper ujoint for it, im using the stock 4 cylinder driveshaft and the new c6 trans i got for it when i did the motor swapcame with a tailstock, i put a ujoint in that tailstock that came with the c6 and mated it up to the 4cyl driveshaft, and about 30 or 40 kms down the road it had terriable vibration problem so i drove it back home hoping nothing was damaged, as soon as i got in my driveway the ujoint, gave out and fell apart, the needle bearings from one of the caps were sitting at the entrance of my driveway , thats how lucky i got, anyone every run into this problem before? not being able to get a ujoint to mate properly to a c6 tailstock, to a stock 4 cyl driveshaft?
Last edited by Scott241; 09-24-2006 at 08:29 PM.
Thread
Thread Starter
Forum
Replies
Last Post