Modular 2V mustang parts
#1
Modular 2V mustang parts
-stock '04 PI cams,and valve springs,brand new never used,great up grade for the non pi 2V guys.Had my heads replaced under warranty for the tic tsb,and at the sametime i had my VT cams,and Comp spings installed....$100
-stock '03 2V 65mm throttle body with minor port work,would still be on my GT,but did the '01 Bullitt intake swap last winter....$50
-stock '03 2V upper intake plenum port matched to gasket....$40
-stock '03 fuel rails for '99 to '04 2V....$60
-stock '03 mint silver GT hood with liner(no hood scoop though)....$80
-stock '03,still like new silver GT spoiler,was on my GT for a few months before i went spoiler delete....$60
-stock upper,and lower rear control arms,lowers need new bushings as i needed the sleeves out of them....$40
-stock '03 GT small headrest(early 2003 GT headrest) in dark charcoal leather,mint,like new....$80
-stock '03 GT springs,maybe 300 kilometers on them,still look brand new....$90
-stock '03 mustang GT silver side skirts,has some wear due to over the years on the underside of both....$60
....everything is located in London,Ontario.
Everything can be had at best offer aswell.
-stock '03 2V 65mm throttle body with minor port work,would still be on my GT,but did the '01 Bullitt intake swap last winter....$50
-stock '03 2V upper intake plenum port matched to gasket....$40
-stock '03 fuel rails for '99 to '04 2V....$60
-stock '03 mint silver GT hood with liner(no hood scoop though)....$80
-stock '03,still like new silver GT spoiler,was on my GT for a few months before i went spoiler delete....$60
-stock upper,and lower rear control arms,lowers need new bushings as i needed the sleeves out of them....$40
-stock '03 GT small headrest(early 2003 GT headrest) in dark charcoal leather,mint,like new....$80
-stock '03 GT springs,maybe 300 kilometers on them,still look brand new....$90
-stock '03 mustang GT silver side skirts,has some wear due to over the years on the underside of both....$60
....everything is located in London,Ontario.
Everything can be had at best offer aswell.
Last edited by 1low03gt; 05-07-2009 at 04:05 PM.
#6
I have no clue.
Post a pic of it if you can,or take some measurements of the square flange that bolts to the intake,and bolt pattern,then we can go from the there.
I would like to say it will,,but there is always that but!
Post a pic of it if you can,or take some measurements of the square flange that bolts to the intake,and bolt pattern,then we can go from the there.
I would like to say it will,,but there is always that but!
Thread
Thread Starter
Forum
Replies
Last Post