Well, i was just looking at the way to route the oil lines on the S/Cer.
As i was pre assembling the oil fittings, i was wondering what to use so it doe not leak.

in the procharger book, it says dont use "Teflon tape or sealant on the fittings, as this could block the oil nozzle."

So what do i use?
in the required tools, it says silicone sealant. so now im confused, can i uses a sealant or what?....

 

Use teflon paste and only go have way down the threads. This will seal it and keep any from going inside the SC.

 

^That's what I would do. They should be tapered threads though and may seal fine w/no sealant at all.

 

thanks for the heads up guys.

 

better to use Teflon tape and go have way down the threads.