1994 3.8L v6 5psd
05-05-2008, 02:58 PM
#1
1994 3.8L v6 5psd
Well guys I dont have the time that she needs anymore, so i've decided she should goto a better home than I can give her at the moment. I am looking to get a 99+ mustang. I've put well over $3000 in parts into her over the last two years and I have a 2000 3.8L motor and transmission waiting to go into the car, but never got around to it. I also have all the pieces needed to do the swap. The car runs perfect I just had the engine because I wanted the extra power from the splitport swap. Also have a carter 88lph HD fuel pump, subframe connectors not installed. Everything will come with the car that I own including the engine for $3000.00. The motor thats not in the car has 51,000kms on it. The motor in the car has 345,XXX but she still runs perfect and no problems I know about.
Parts recently replaced:
Front end is basically new.
Tie rods
Ball joints
Rack and pinion
Struts and shocks (Monroe Sensatrac)
Springs (Steeda sport springs)
Calipers (Front & Rear)
Rotors (Powerslot front / Stock rear)
Pads (Hawk HPS front / Stock rear)
Water pump
Idler pulley
Plugs, Wires, Coil.
Been running synthetic oil since I got her.
I'm sure i'm missing stuff as well later when I get home I will go through all my reciepts and see if there is anything else i'm missing. This car will be AS-IS and would make a great project for someone or a nice summer cruiser. I havnt decided if the rims will go with the car or not. Depending on the interest I might include them
Thanks for looking, any questions PM me please. Will post pictures later when I get home.
Parts recently replaced:
Front end is basically new.
Tie rods
Ball joints
Rack and pinion
Struts and shocks (Monroe Sensatrac)
Springs (Steeda sport springs)
Calipers (Front & Rear)
Rotors (Powerslot front / Stock rear)
Pads (Hawk HPS front / Stock rear)
Water pump
Idler pulley
Plugs, Wires, Coil.
Been running synthetic oil since I got her.
I'm sure i'm missing stuff as well later when I get home I will go through all my reciepts and see if there is anything else i'm missing. This car will be AS-IS and would make a great project for someone or a nice summer cruiser. I havnt decided if the rims will go with the car or not. Depending on the interest I might include them
Thanks for looking, any questions PM me please. Will post pictures later when I get home.
Last edited by 94STANGR; 05-05-2008 at 09:36 PM.
02-08-2009, 09:41 PM
#10
CMOC Newbie
Join Date: Jan 2009
Location: Brandon, Manitoba
Posts: 9
do you still have her, or did she sell.
