FS: 289 engine for parts or rebuilding
#1
FS: 289 engine for parts or rebuilding
Hey guys
I have the original 125,000 mile 289 out of my 68 Cougar, that I'd like to move along. It was running when removed, but had a bottom end knock.
This would be good for a rebuilder, or even just use the heads to take advantage of the smaller chambers to get a C.R. increase on a later engine. It is a longblock only, no manifolds or covers.
$150 OBO takes it. I can deliver in the GTA, if you have a way to get it off the back of a pickup at your end.
Please contact me via p.m., or email at fastedn2001 AT yahoo DOT ca
thanks,
Ed N.
I have the original 125,000 mile 289 out of my 68 Cougar, that I'd like to move along. It was running when removed, but had a bottom end knock.
This would be good for a rebuilder, or even just use the heads to take advantage of the smaller chambers to get a C.R. increase on a later engine. It is a longblock only, no manifolds or covers.
$150 OBO takes it. I can deliver in the GTA, if you have a way to get it off the back of a pickup at your end.
Please contact me via p.m., or email at fastedn2001 AT yahoo DOT ca
thanks,
Ed N.
Thread
Thread Starter
Forum
Replies
Last Post
lightz
Mustang Parts for sale
1
08-21-2019 05:32 PM