2.3L turbo treads
ok so i have only built 2 motors in my life a 2.3L stroker talon engine and a 2.3L non turbo ford motor. now if i cant sell the mustang i will be rebuilding the whole car and selling for profit.but what all should i do to it? i have plans to have it run a 90 degree rotoated throttle body but i dont know where to get one??? either that or i would really like to run a plenium intake manifold but again where can i get one for a 2.3L??? other than that i plan to have it run a big intercooler with .20 bored pistons, possibly do the volvo head conversion but if not i will just find ajustible cam gears for my car. i am also looking at a T4 turbo and turbo joe fuel rail with 750cc injectors. i would like to run the 5.0 rear gears in the car but dont wanna sacrifice my acceleration as i have herd that really kills it. i will be getting better rods and clutch and a new 6 speed tranny if kept plus a blue with black paint job...... but thats just the plans
|
anyone??? where can i get a 90 degree rotoated throttle body or a plenium intake manifold and do you know if 5.0 rear gears would slow down the cars acceleration???
|
yes DO NOT! put the 8.8 rear end with stock v8 gearing in it or u will were out ur clutch like u would'nt beleve
also go to "www.40bob.com" for the 90' upper intake lmk how u make out |
if i was u and u were just going to sell this car after ur done
i think ur wasting ur money with the turbo joe fuel rails and every thing this is wat im running ported upper&lower intakes ported stock turbo head 60mm t bird throttle body stock intercooler stock t3 turbo stock exhoust and bottom end has never been cracked open befor im running 300Hp and 18psi of boost all this cost me was under 2,000 so u do the math |
All times are GMT -5. The time now is 09:49 PM. |
© 2024 MH Sub I, LLC dba Internet Brands