2.3L turbo treads
#1
2.3L turbo treads
ok so i have only built 2 motors in my life a 2.3L stroker talon engine and a 2.3L non turbo ford motor. now if i cant sell the mustang i will be rebuilding the whole car and selling for profit.but what all should i do to it? i have plans to have it run a 90 degree rotoated throttle body but i dont know where to get one??? either that or i would really like to run a plenium intake manifold but again where can i get one for a 2.3L??? other than that i plan to have it run a big intercooler with .20 bored pistons, possibly do the volvo head conversion but if not i will just find ajustible cam gears for my car. i am also looking at a T4 turbo and turbo joe fuel rail with 750cc injectors. i would like to run the 5.0 rear gears in the car but dont wanna sacrifice my acceleration as i have herd that really kills it. i will be getting better rods and clutch and a new 6 speed tranny if kept plus a blue with black paint job...... but thats just the plans
#4
if i was u and u were just going to sell this car after ur done
i think ur wasting ur money with the turbo joe fuel rails and every thing
this is wat im running
ported upper&lower intakes
ported stock turbo head
60mm t bird throttle body
stock intercooler
stock t3 turbo
stock exhoust
and bottom end has never been cracked open befor
im running 300Hp and 18psi of boost
all this cost me was under 2,000
so u do the math
i think ur wasting ur money with the turbo joe fuel rails and every thing
this is wat im running
ported upper&lower intakes
ported stock turbo head
60mm t bird throttle body
stock intercooler
stock t3 turbo
stock exhoust
and bottom end has never been cracked open befor
im running 300Hp and 18psi of boost
all this cost me was under 2,000
so u do the math
Thread
Thread Starter
Forum
Replies
Last Post