Have you been on a dyno? what was your baseline?

 

donno yet but I will get pretty much a baseline since as far as performance goes I only have a k&n filter, 2 removed cats and flows.

Then I will get it dynod again after the mods are installed

 

Dynod 229.4 hp @ 280 lbs of torque stock.
Then with a few mods like ported upper plenum,catted mac h pipe,flowmaster mufflers,timing adjuster,and cold air intake,she dynod 250.79 hp @ 292 lbs of torque.
I have sence taken out the cold air intake ,and timing adjuster,and added a K&N drop in air filter,and a SCT chip. But no new numbers on that.
But plan on getting new numbers after intake spacer,and VT stage II cam install. :biggrin: