need help with vacuum lines
06-10-2013, 02:44 PM
#1
CMOC Newbie
Thread Starter
Join Date: Jun 2013
Location: Geraldton, Ontario
Posts: 2
need help with vacuum lines
HI, I need help running all the vacuum lines from a '88 5.0 litre Mustang into a FFR Cobra kit...the air pump has been removed. I found a few diagrams, but they are still too complicated.... I am uncertain which sensors do what, etc....any help would be appreciated.
09-04-2013, 06:51 PM
#2
CMOC Newbie
Join Date: Apr 2007
Location: Torbay ,NFLD
Posts: 6
I just finished my engine so I will try to remember what I did. Coming out under the front of the intake is the line for the vent valve. Out the back is a big one for the vacuum tree,one for the fuel pressure reg,and one to the EGR control valve and the TAD &TAB valves. Off the tree one goes to the brake booster,another to the cruse control, and another to the heater and vac res.in right fender. If you removed the air pump you don't need the TAD&TAB valves.good luck
Thread
Thread Starter
Forum
Replies
Last Post
