asap need torque spec
ยต 2. Note:
Refer to the location note made during removal and make sure the bolts are installed in the correct location.
Install the upper intake manifold. Tighten the bolts in the sequence shown in three stages:
l Stage 1: tighten to 6Nm (53 lb-in).
l Stage 2: tighten to 8Nm (71 lb-in).
l Stage 3: rotate an additional 90 degrees.
Refer to the location note made during removal and make sure the bolts are installed in the correct location.
Install the upper intake manifold. Tighten the bolts in the sequence shown in three stages:
l Stage 1: tighten to 6Nm (53 lb-in).
l Stage 2: tighten to 8Nm (71 lb-in).
l Stage 3: rotate an additional 90 degrees.
Thread
Thread Starter
Forum
Replies
Last Post
