5 spd swap
#2
well all I know is that you need:
- to cut a hole for the pedel
- u need the master clutch cylinder
- u need the tranny
- and well I guarentee a weekend
- and some help
#5
the automatics already ahve a hole int he firewall for the clutch cable to go through, it has a rubber groumet on it if you have an auto, so remove the groumet and feed the clutch cable though it. Yeah the swap is not too hard, you will need to get the EEC reprogrammed though as it will want to shift thinking it still has the auto, thast the good thing about going from auto to 5 speed, you can use the EEC from the auto car and turn off the electronic shifting, where as if you were to go from 5-sopeed to auto you would need an auto EEC as you can't turn the auto shifting on in a computer that didn't have it
#6
Originally Posted by V6Sprout
the automatics already ahve a hole int he firewall for the clutch cable to go through, it has a rubber groumet on it if you have an auto, so remove the groumet and feed the clutch cable though it. Yeah the swap is not too hard, you will need to get the EEC reprogrammed though as it will want to shift thinking it still has the auto, thast the good thing about going from auto to 5 speed, you can use the EEC from the auto car and turn off the electronic shifting, where as if you were to go from 5-sopeed to auto you would need an auto EEC as you can't turn the auto shifting on in a computer that didn't have it
How much roughly to get the EEC programmed? Other than that I need the tranny, and clutch cable/pedal and some time and its good?
#7
You will need a Diablo or SCT tuner and a programmer to do it. (to write the reguired changes such as removing the neutral rev limiter etc) I had the tuner as I have installed a ProCharger and new rear gears etc. In your case it might be easier and cheaper to get a an ECU from a 5-speed car.
#8
I'm sorry I didn't tell u before but I already have a 5 speed :1: but the info you gave me was great for a furture referance or If i ever need to tell any body elseso Thanx again for the info cuz many people don't know what work is involved with the swap
thanks
thanks
Thread
Thread Starter
Forum
Replies
Last Post
Pete
Mustangs for sale
0
03-07-2006 11:56 AM
Pete
Mustangs for sale
0
03-03-2006 03:04 PM
Pete
Mustangs for sale
4
02-20-2006 07:39 AM